Follow This Great Article About Woodworking To Help You

Follow This Great Article About Woodworking To Help You

Whether you are a professional woodworker, or just do it as a hobby, there is always good reason to take time to learn more about the skill. There are always new tricks that are discovered, as well as new tools to hit the market to make your work easier. If you want to learn more you need to read the article that follows.

It is always a good idea to have a pre-stain conditioner for the wood you’re planning to stain. If you use a pre-stain conditioner, you will be less likely to notice any blotches or irregularities in your finished project. They will make the wood smooth and allow the stain to go on evenly.

Organize your shop’s extension cords to keep your shop safe and tidy. You can make your own cord keeper with nothing more than a scrap piece of wood. Simply cut a piece of wood in the shape of an I and wrap each of your extension cords around the wood.

Practice some table saw safety. When crosscutting with a table saw, set your cut length with the block clamped to your fence. Do not use your fence directly for avoiding get kicked back by a board directly. You need to clamp the block of wood to your fence before your blade. The board’s end is free of the fence when you cut and after you cut.

When sanding a piece of lumber, beginning with a coarse sandpaper. Remove the excess dust from the lumber. Then, once the largest scratches are removed, sand again with a smoother sandpaper. Follow this sanding with a tack cloth. Continue using smoother sandpaper until the lumber feels smooth when you run your hand across it.

Glue can cause nasty stains on your finished work. You can eliminate stains easily using a piece of tape. First, clamp your wood together without any glue. Put a piece of tape over the joint. Cut the tape on the joint with a sharp knife. You can now clamp the wood together with glue and any excess will ooze onto the tape, not the wood.

If you are cutting, sanding, or finishing something small, get out your hot glue gun. Affix the item you are working on to the end of a pedestal stick. Hot glue holds better than a clamp, and small objects are impossible to clamp anyway. Just be careful when pulling the piece off to avoid tearing the back side of the wood.

There are many tools used for woodworking, but you may not want the expense involved with acquiring them. Look at your project and see if there might be a more reasonable solution to this cost. You may find that a cheaper tool can give you the same result as some of the expensive ones.

Be safe when using your table saw. When executing a crosscut, set the length for the cut by clamping a wooden block to the fence. This is preferred over just using the fence alone, because it prevents your board from springing back. This will also keep the board end open so you can cut.

Many professional recommend finishing the separate pieces of the project before it is assembled. This method makes finishing much easier and if the wood shrinks a little in the future, there will be no bare wood exposed. However, it is important to keep the finish off any surfaces that will be glued.

As you read at the beginning of this article, there is always something new to learn about the field of woodworking, no matter how long you have been doing it. Now that you have read the article, you know that is true because you have surely learned something yourself. Now all you need to do is apply the tips so that they become part of your routine.

X